Two types of the programmable features to reduce cross thread. Soft Start : Lower the no load speed to the tool lowest rpm for a programmable time after trigger is pulled. Reverse Start : Small reverse rotation for thread alignment then rotate forward

This function prevents the tool from operating within a selected time period after it automatically stops from the torque control function. The switch will not operate even if engaged during this time period.

Speed can be controlled by use of the trigger. Speed control function ON and OFF can be selected.

The tool doesn’t activate Snug Torque Detection mode and ignores loads in the middle of rundown for a selected time period.

Tool shuts off when the rundown exceeds its upper angle limit to prevent the material from damaged.

The tool is prevented from operating in reverse rotation when this function is ON.

When this function is ON and tool stops before snug point due to trigger release, the rundown result isn't recorded.

When the total fastening times (impact tools)/numbers (screwdrivers) are within 1 hours/10,000 fastenings of the preset maintenance interval, the display blinks notifying the operator. Once the tool reaches the preset interval, the tool is looked out from further use. (Number of setting: 0-99 hours/0-990,000 fastenings)

RPM can be adjusted depending on socket length to stabilize torque even with long socket.

(h1: for 150mm socket, h2: for 250mm socket)

If the clutch is activated before the programmable minimum runtime, the tool alerts the operator to a NOK fastening. (Time setting:0.1-3.0sec, 0.1sec per stage)

Example with 3.0sec. normal time setting